Current Filters
More Filters:
Most Popular
Body Jewelry
Other
Shirt sizes
Ring sizes
Ear
Nose
Other
Face
Genital
Discontinued 14g Non-Conversion Threadless Bezel Set Cabochon End
(4.9) LAST CHANCE
Qty
Sold as a SINGLE
$ USD

Neometal has discontinued this style of threadless end. These are made to fit an old style of threadless compatible labret shafts, exclusively.

They can connect to the 14g labret posts in this listing.

These are for straight pieces of jewelry (barbells or labrets) made by NEOMETAL only.


NeoMetal does not use any adhesives or glues on any opal/stone set into a flat surface like the bezel set ends, and the opal/stone may spin within the setting. This is not considered a defect. Each piece is put through a stress test to ensure the crimping of the setting is wide enough to hold the opal/stone in place.


About threadless jewelry
Threadless jewelry is a push pin technology. The removeable end (dark grey) has a slightly curved pin. This pin straightens out when inserted into the shaft (light grey). The resulting spring tension force holds the two pieces together securely.

  • STEP 1 - Insert the pin about halfway into the shaft.
  • STEP 2 - Bend the pin SLIGHTLY by hand as shown. For a tighter fit bend the pin more. For an easier fit straighten the pin out a little.
  • STEP 3 - Push in the removable end to close.
  • STEP 4 - To remove, pull apart both ends. If the jewelry is tight, add a slight twisting motion while you pull out the removable end.
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:

Jewelry is measured through a gauge system (see chart below). The higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different.

CONVERSION CHART:
Gauge Millimeter Inch
16g 1.2mm 3/64"
14g 1.6mm 1/16"
12g 2mm 5/64"
10g 2.4mm 3/32"
8g 3.2mm 1/8"
6g 4mm 5/32"
4g 5mm 3/16"
2g 6mm 1/4"
0g 8mm 5/16"
00g 9mm to 10mm 3/8"
  11mm 7/16"
  13mm 1/2"
  14mm 9/16"
  16mm 5/8"
  19mm 3/4"
  22mm 7/8"
  25mm 1"
  26.9mm 1-1/16"
  28.5mm 1-1/8"
  30.1mm 1-3/16"
  31.7mm 1-1/4"
  33.3mm 1-5/16"
  34.9mm 1-3/8"
  36.5mm 1-7/16"
  38.1mm 1-1/2"
  39.6mm 1-9/16"
  41.2mm 1-5/8"
  44.4mm 1-3/4"
  47.6mm 1-7/8"
  51mm 2"
Enlarged example of 1" on ruler
Ruler example
Customer Photos
Customer Reviews (117)
4.9 out of 5 stars
105% (46)
9% (4)