Internally threaded jewelry is where the shaft has threads inside the metal. So basically the ball has threads sticking out of it that screw down into the metal shaft.
Anatometal jewelry has a flawless finish, is made from implant grade materials, & all jewelry is made in the USA.
THIS IS A LIMITED ITEM!
Limited jewelry is usually re-stocked much less frequently and is harder for us to get from the manufacturer. So get it while you can, while it's available!
This page has both threaded and threadless ends on it:
Threadless ends are made to be worn in threadless posts. For these ends, we recommend these posts.
Threaded ends are made to be worn in a internally threaded post. For these ends, we recommend these posts.
About threadless jewelry
Threadless jewelry is a push pin technology. The removeable end (dark grey) has a slightly curved pin. This pin straightens out when inserted into the shaft (light grey). The resulting spring tension force holds the two pieces together securely.
STEP 1 - Insert the pin about halfway into the shaft.
STEP 2 - Bend the pin SLIGHTLY by hand as shown. For a tighter fit bend the pin more. For an easier fit straighten the pin out a little.
STEP 3 - Push in the removable end to close.
STEP 4 - To remove, pull apart both ends. If the jewelry is tight, add a slight twisting motion while you pull out the removable end.
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:
Jewelry is measured through a gauge system (see chart below). The higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different.