Sporting a secure, hinged mechanism and polished finish, these steel alien head clicker rings are not just fashionable; they're out of this world!
I want to believe.
The below measurements are approximate:
The entire clicker measures 11.5mm tall by 10mm wide The inner wearable area measures 8mm wide by 5mm tall from the alien design to the top of the clicker ring Made of stainless steel
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:
14g - 3/4 inch (5mm balls)
6g - 1/2 inch (8mm balls)
Jewelry is measured through a gauge system (see chart below). The
higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different. CONVERSION CHART:
9mm to 10mm
Measuring septum jewelry
Septum jewelry is measured by the diameter straight across the center of a ring. How far it sits below your nose will be dependant on where you're pierced. We've given an example below of a septum that's pierced a bit lower (see the side shot) and how it will look with different diameters. The general rule is, the smaller the diameter the tighter the fit.
5/16" (~8mm) diameter
3/8" (~10mm) diameter
1/2" (~12mm diameter)
Enlarged example of 1" on ruler