The below measurements are approximate:
The Maya end measures 7mm in diameter The center CZ gem measures 3mm The smaller surrounding CZ gems measure 1.5mm These are for straight pieces of jewelry (barbells or labrets) made by NEOMETAL only. This end is made with 14K rose gold, 14K yellow gold, or 14K white gold
They can connect to any of the labret posts in
About threadless jewelry
Threadless jewelry is a push pin technology. The removeable end (dark grey) has a slightly curved pin. This pin straightens out when inserted into the shaft (light grey). The resulting spring tension force holds the two pieces together securely.
STEP 1 - Insert the pin about halfway into the shaft. STEP 2 - Bend the pin SLIGHTLY by hand as shown. For a tighter fit bend the pin more. For an easier fit straighten the pin out a little. STEP 3 - Push in the removable end to close. STEP 4 - To remove, pull apart both ends. If the jewelry is tight, add a slight twisting motion while you pull out the removable end.
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:
14g - 3/4 inch (5mm balls)
6g - 1/2 inch (8mm balls)
Jewelry is measured through a gauge system (see chart below). The
higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different. CONVERSION CHART:
9mm to 10mm
Enlarged example of 1" on ruler