30948 Material(s): 316L Stainless Steel, Rhodium plated
These assorted Halloween stud earrings are made using plated base metal designs with steel earring prongs or wires. Each pair of studs includes either butterfly backs or push pin backs.
The below measurements are approximate:
The demon skull studs measure 10.5mm tall by 9.5mm wide The spider studs measure 10.2mm tall by 10.7mm wide The lips measure 6.5mm tall by 8.5mm wide The vertebrae studs measure 20.5mm tall by 7.5mm wide The rabbit mask studs measure 16.5mm tall by 8mm wide The tooth dangle earrings measure 15.5mm tall by 7mm wide The death tree dangle earrings measure 41mm tall by 14mm wide The captured skull measures 8.7mm tall by 5.7mm wide The knight's helmet measures 10.7mm tall by 10.7mm wide
THIS IS A LIMITED ITEM!
Limited jewelry is usually re-stocked much less frequently and is harder for us to get from the manufacturer. So get it while you can, while it's available!
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:
14g - 3/4 inch (5mm balls)
6g - 1/2 inch (8mm balls)
Jewelry is measured through a gauge system (see chart below). The
higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different. CONVERSION CHART:
9mm to 10mm
Enlarged example of 1" on ruler