The White Topaz is a hand cut, genuine stone featured in a low profile cabochon settings, which allows its unique sparkle and natural charm to really stand out
This end will fit
most of these posts that are 18g/16g/14g.
Neometal is very proud to be able to say they use no glue or adhesives in any of their products. This means you can see clear to the bottom of our beautiful Rose Cut titanium settings! For this reason, they do not recommend anodizing the new Rose Cut Gem, doing so can result in anodization occurring under the gem and causing the gem to look discolored.
About threadless jewelry
Threadless jewelry is a push pin technology. The removeable end (dark grey) has a slightly curved pin. This pin straightens out when inserted into the shaft (light grey). The resulting spring tension force holds the two pieces together securely.
STEP 1 - Insert the pin about halfway into the shaft. STEP 2 - Bend the pin SLIGHTLY by hand as shown. For a tighter fit bend the pin more. For an easier fit straighten the pin out a little. STEP 3 - Push in the removable end to close. STEP 4 - To remove, pull apart both ends. If the jewelry is tight, add a slight twisting motion while you pull out the removable end.
Pre-orders are items scattered throughout the site in their appropriate categories. They will ALWAYS be noted in the
title with "PRE-ORDER". Basically you get a lot more control over the item you want and its top quality.
Majority of pre-orders are sent to the manufacturers weekly, but there are some company that are placed every other
week.
Pre-order time frames are not chosen by Bodyartforms, but are given to us by each manufacturer on how long it will
take them to complete our orders. The time frame varies depending on the manufacturer and each pre-order item
will have the estimated time frame listed on the item page.
All time frames are subject to change without notice. The time frames are on how long it takes the
piece
to be made and it does not include shipping time.
Your
ENTIRE ORDER will be held until we receive all your items. If you want the other items to come
before the
pre-order item then you need to
PLACE A SEPERATE ORDER . Picking express or priority mail will not get your pre-order item to you
faster,
it will only speed up the process AFTER we get your item and ship your order out. Once we receive a complete order,
we will ship the order out within 24 hours.
Once an order has been placed with a manufacturer, we are UNABLE TO MAKE ANY CHANGES! Please double check your specs
and that you order the correct size beforehand.
If you want to cancel, remove or change a pre-order item there will be a
15% restocking fee on each item because we cannot stop the pieces from being made, nor can we
return them
to the manufacturer.
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:
14g - 3/4 inch (5mm balls)
6g - 1/2 inch (8mm balls)
Jewelry is measured through a gauge system (see chart below). The higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different.
CONVERSION CHART:
Gauge
Millimeter
Inch
16g
1.2mm
3/64"
14g
1.6mm
1/16"
12g
2mm
5/64"
10g
2.4mm
3/32"
8g
3.2mm
1/8"
6g
4mm
5/32"
4g
5mm
3/16"
2g
6mm
1/4"
0g
8mm
5/16"
00g
9mm to 10mm
3/8"
11mm
7/16"
13mm
1/2"
14mm
9/16"
16mm
5/8"
19mm
3/4"
22mm
7/8"
25mm
1"
26.9mm
1-1/16"
28.5mm
1-1/8"
30.1mm
1-3/16"
31.7mm
1-1/4"
33.3mm
1-5/16"
34.9mm
1-3/8"
36.5mm
1-7/16"
38.1mm
1-1/2"
39.6mm
1-9/16"
41.2mm
1-5/8"
44.4mm
1-3/4"
47.6mm
1-7/8"
51mm
2"
Enlarged example of 1" on ruler
