Current Filters
More Filters:
Body Jewelry
Regular Jewelry
Other
Shirt sizes
Ring sizes
Ear
Nose
Other
Face
Genital
Defaults to contain ANY selected colors
Discontinued Heart Rook Clicker Ring
LAST CHANCE
Sorry, but this product is currently out of stock.
This item will not be re-stocked.
Adorn yourself with this dainty, but no less lovely heart clicker ring.

The below measurements are approximate:

  • The heart measures 4mm tall by 4.2mm wide
  • The gem measures 1mm in diameter
  • The entire ring measures 11.2mm tall by 9.2mm wide
  • The inner diameter measures 8.3mm tall by 5.8mm wide
In our drop-down menus for adding to cart, we show the gauge of the item you are ordering, then the length/diameter, then the ball size if it has any:

Jewelry is measured through a gauge system (see chart below). The higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different.

CONVERSION CHART:
Gauge Millimeter Inch
16g 1.2mm 3/64"
14g 1.6mm 1/16"
12g 2mm 5/64"
10g 2.4mm 3/32"
8g 3.2mm 1/8"
6g 4mm 5/32"
4g 5mm 3/16"
2g 6mm 1/4"
0g 8mm 5/16"
00g 9mm to 10mm 3/8"
  11mm 7/16"
  13mm 1/2"
  14mm 9/16"
  16mm 5/8"
  19mm 3/4"
  22mm 7/8"
  25mm 1"
  26.9mm 1-1/16"
  28.5mm 1-1/8"
  30.1mm 1-3/16"
  31.7mm 1-1/4"
  33.3mm 1-5/16"
  34.9mm 1-3/8"
  36.5mm 1-7/16"
  38.1mm 1-1/2"
  39.6mm 1-9/16"
  41.2mm 1-5/8"
  44.4mm 1-3/4"
  47.6mm 1-7/8"
  51mm 2"
Measuring septum jewelry
Septum jewelry is measured by the diameter straight across the center of a ring. How far it sits below your nose will be dependant on where you're pierced. We've given an example below of a septum that's pierced a bit lower (see the side shot) and how it will look with different diameters. The general rule is, the smaller the diameter the tighter the fit.
5/16" (~8mm) diameter
3/8" (~10mm) diameter
1/2" (~12mm diameter)
Enlarged example of 1" on ruler
Ruler example