Threadless 18k Gold Purity End
- Product # 27019
- Material(s): Synthetic opals, 18K, Solid Rose gold, Solid Yellow gold, Stone, Synthetic gemstones, 316LVM ASTM F-138 Implant Grade Steel, Genuine gemstones
- Made in USA
The below measurements are approximate:
- These ends are available with 2mm or 3mm inlay and in solid 18K yellow gold or 18K rose gold
- 2mm inlay ends have a total outer diameter of 4.7mm
- 3mm inlay ends have a total outer diameter of 6.8mm
- The threadless post of ends are made with implant grade steel
There is only a slight difference in color between the rose gold and gold materials.
Threadless ends are made to be worn in threadless posts. For these ends, we recommend these posts.
More threadless jewelry can be found here.
- STEP 1 - Insert the pin about halfway into the shaft.
- STEP 2 - Bend the pin SLIGHTLY by hand as shown. For a tighter fit bend the pin more. For an easier fit straighten the pin out a little.
- STEP 3 - Push in the removable end to close.
- STEP 4 - To remove, pull apart both ends. If the jewelry is tight, add a slight twisting motion while you pull out the removable end.
Jewelry is measured through a gauge system (see chart below). The higher the gauge number the smaller the wire is. A standard "earring" is usually 20 gauge. Jewelry gauges/sizes can vary between manufacturers. There is no universal regulation on companies to make a standard size in body jewelry. A big part of this is that some jewelry is made overseas and measured in millimeters. And in the USA jewelry is measured in inches/gauges. So many times jewelry can be anywhere from .5mm to 1mm different.CONVERSION CHART: